DICHTUNG, ROD

550 954 13 DICHTUNG, ROD is the little workhorse that keeps your hydraulic cylinders from weeping fluid all over the place. Think of it as the barrier that holds the pressure in, making sure the rod extends and retracts with the force it’s designed for. Without it doing its job, you just can't get the consistent push or pull you need from that cylinder, whether it's for feed, boom, or even a simple clamp.

When this dichtung starts to go, usually what happens is you’ll notice a film of hydraulic oil building up on the bohrstange itself, or even dripbolzeng down the zylinder body. If it gets bad enough, you might even hear the pumpe working harder than usual, or the zylinder might start to drift or move sluggishly under load. That loss of pressure means the bohrgerät isn't getting the full power it needs, and you're just wasting fluid and energy.

When you're swapping one of these out, always give the rod a good once-over for any nicks or scratches – even a tiny imperfection can tear up a new Dichtung in no time. And don't forget to check the wiper Dichtung too; it’s the first line of defense against external crud getting in and chewing up this rod Dichtung prematurely. A little bit of care during installation goes a long way to prevent repeat failures.