PEDAL PLATE

028 622 20 PEDAL PLATE is one of those bits that keeps the hydraulic fluid where it belongs, usually around a rod or a shaft. Think of it as the barrier that holds the primary seal in place, or sometimes it *is* the sealing surface itself, working to prevent pressure leaks or stop dirt and water from getting into critical components. Without it, or if it's compromised, you're looking at contamination or fluid loss pretty quickly.

When this PEDAL PLATE starts to go, you'll usually notice a slow, weeping leak around the area it's supposed to be sealing. It might not be a gush right away, but that tell-tale film of oil or hydraulic fluid collecting on the cylinder rod or pump housing is your first clue. If it's really bad, or if the plate itself is warped or cracked, you might even hear a slight hiss if it's an air system, or see a noticeable drop in system pressure if it's hydraulic, leading to sluggish movements or a loss of power in that specific function. Sometimes, it's just dirt ingress, and then you've got bigger problems brewing inside.

Replacing one of these isn't usually a huge job, but it's critical to make sure the mating surfaces are absolutely clean before you put the new one in. Any nicks, burrs, or even a speck of grit can compromise the new seal almost immediately. And don't forget to check the condition of the primary seal it's working with – often, if the plate is worn, the seal itself is probably due for replacement too. Always use the right torque spec if there are fasteners; over-tightening can warp it, under-tightening means it won't seal properly.