SIDE PLATE

029 623 70 SIDE PLATE is usually there to keep things running true, often acting as a wear surface or a guide for moving components. Think about it on a feed beam, for instance; it helps keep the drill string or the feed carriage tracking straight, taking the brunt of any side loads or minor misalignments. It’s not just a cover; it’s a working surface that prevents more expensive components from wearing out prematurely.

When this SIDE PLATE starts getting thin or chewed up, you’ll definitely notice things getting sloppy. Usually what happens is you get increased play in whatever it’s guiding, leading to excessive vibration or even a noticeable 'clunk' when the system changes direction. On a feed, that might translate to the drill string binding up or the feed carriage not moving as smoothly, sometimes even causing premature wear on the rollers or main guide rails because the load isn't distributed right anymore. Keep an eye out for scoring or uneven wear patterns on the plate itself; that’s a dead giveaway.

Replacing one of these isn't usually a huge job, but don't just bolt on the new one and forget about it. Always take a minute to check the mating surfaces and any adjacent components for wear or damage. Sometimes, a worn SIDE PLATE is a symptom of a deeper alignment issue or a problem with the component it's meant to guide. Also, make sure to clean up any old grease or debris thoroughly before installation; a little grit in the wrong spot can chew up a new plate pretty quick.