RUBBER SEAL

345 696 08 SEAL, RUBBER this little guy is usually found doing the dirty work of keeping hydraulic fluid where it belongs, or sometimes keeping dust and water out of a bearing or a cylinder rod. Think of it as the bouncer for your oil, making sure it doesn't sneak out and cause a mess, or letting contaminants sneak in and wreck things. It’s a pretty critical barrier, often working under a fair bit of pressure or just keeping things clean in a dynamic spot.

If this seal starts to go, you’ll usually notice a slow weep first, maybe just a damp spot around a cylinder rod or a fitting. Ignore that, and it’ll turn into a steady drip, then a stream. On a drill, that means you're losing hydraulic pressure where you need it, or worse, you're getting grit into a system that really can't handle it. I’ve seen cylinders get scored up fast because a simple seal let go and nobody caught it early enough. You might even feel a bit of sluggishness in a function if it’s an internal seal letting pressure bypass.

When you're replacing one of these, always make sure the surface it's sealing against is perfectly clean and smooth. Even a tiny scratch can tear a new seal right away. Don't forget to check for any burrs on the shaft or housing edges during installation; that's a common rookie mistake that'll have you doing the job twice. A little bit of clean hydraulic oil or grease on the seal itself before you slide it in helps a ton too, just to prevent any initial damage.