WINDOW KIT

550 135 65 WINDOW KIT is the whole assembly that seals off the operator's cab from the outside world. It’s more than just a piece of glass; it’s the frame, the seals, and all the bits that keep the dust, noise, and whatever else is flying around on a drill site from getting in. Crucially, it gives the operator a clear view of what’s happening, which is non-negotiable for safe and efficient work.

When this kit starts to wear out, you’ll usually notice a few things. A common one is drafts in the cab, especially around the edges – that means the seals are shot. You might also find the cab getting a lot noisier than it used to be, which is a real pain on a busy site and can make communication tough. If the glass itself is getting hazy, scratched up, or even cracked, then visibility goes right down the drain, making it harder to spot holes or maneuver the rig safely. And of course, water leaks when it rains are a dead giveaway, making a mess and potentially messing with the cab's electricals.

Swapping one of these out isn't too complicated, but there are a couple of things to watch for. Always make sure you thoroughly clean out the old seal channels in the frame before you even think about putting the new kit in. Any old gunk or rust left behind will compromise the new seal, and you'll be doing the job again sooner than you want. Also, when you're tightening everything up, go snug, not gorilla-tight; you don't want to crack the new glass or strip out the fasteners. Just a bit of common sense goes a long way here.