O-RING

550 987 87 O-RING is usually found tucked into a guide channel, acting as a sacrificial buffer between moving steel parts. Think of it as the quiet workhorse that keeps your feed beam or boom sections sliding smooth and true, preventing gouging and premature wear on the main structural components. It’s there to take the abuse so your expensive steel doesn't get chewed up, maintaining proper alignment and reducing friction in the system.

When these pads start to wear thin, or if one breaks up, you’ll definitely notice things getting a bit sloppy. The most common sign is usually increased slop or play in whatever component it’s guiding – maybe your feed beam starts rattling more than usual, or a boom section feels a bit loose when extending. Sometimes you even get a grinding noise as metal starts making contact where it shouldn't, or the movement just feels sluggish and uneven. It’s a clear sign that the clearances are opening up, and you’re starting to put unnecessary stress on other parts, leading to accelerated wear elsewhere.

Replacing these isn't usually a major job, but it's important to do it right. When you're swapping them out, always give the mating steel surface a good once-over for any scoring or damage – sometimes a worn pad lets the steel get chewed up, which will just eat through your new pad faster. And don't just replace the obvious worn one; take a moment to check all the pads in that assembly. They usually wear in pairs or sets, and you don't want to be back in there next week for another one, or worse, dealing with more significant damage.