TILT CYLINDER

560 133 14 TILT CYLINDER is what gives you the ability to pitch that feed beam or boom up and down. It's a pretty straightforward hydraulic cylinder, but it's absolutely crucial for getting your drill string aligned just right. Whether you're setting up for a new hole or trying to get that perfect angle for a bench, this cylinder does the heavy lifting, making sure you hit your mark consistently.

When this cylinder starts wearing out, usually the first thing you’ll notice is that the feed beam or boom doesn't hold its position anymore. It’ll start to drift, especially under load, or you might see it sag slowly after you've set your angle. Sometimes, you'll hear a bit of a groan or feel some shuddering when you try to actuate it, indicating internal bypass or a seal issue. Don't ignore those little drips around the rod seal either; that's a pretty clear sign it's on its way out.

Look, when you're swapping one of these out, make sure you properly bleed the system afterward. Air in the lines will make it spongy and inconsistent, which is just annoying and makes fine adjustments a pain. Also, always double-check your mounting pins and bushings. They take a beating, and a worn pin can cause premature wear on your new cylinder, not to mention making it a pain to align everything properly.