PARTS KIT

560 271 51 PARTS KIT is typically what you'd grab when you're rebuilding one of those main hydraulic cylinders, maybe for the feed or the boom. This kit brings together all the necessary seals, wipers, and O-rings that keep the oil where it belongs, preventing internal bypass and external leaks. Essentially, it's what makes sure your cylinder holds pressure and moves smoothly without any slop or loss of power.

When these seals start to go, you'll usually notice things getting a bit sloppy. For a cylinder, that might mean the rod drifts down on its own when it should be holding position, or maybe the feed pressure just isn't what it used to be. You might even see oil weeping around the rod or the end caps. If it's an internal seal failure, you won't see the leak, but the cylinder will feel weak, or it'll chatter a bit under load because the oil's bypassing internally instead of doing its job.

When you're putting this kit in, don't just slap the new seals on. Always clean out the gland and the piston groove thoroughly; any old crud or burrs will chew up your new seals in no time. And here's a common one: people often forget to check the condition of the rod itself for pitting or scratches. A perfect new seal won't last five minutes if the surface it's sealing against is already damaged. A bit of clean hydraulic oil on the seals helps them slide in without tearing, too.