SLEEVE

086 160 68 BUSHING is typically a wear SLEEVE designed to protect more critical, expensive components from direct friction and abrasion. Think of it as a sacrificial liner, often found in pivot points, cylinder mounts, or even within certain hydraulic components where metal-on-metal contact needs to be managed. It provides a smooth, low-friction surface for movement, taking the brunt of the wear so the main housing or shaft doesn't get chewed up, which would be a much bigger, more costly repair.

When this SLEEVE starts to wear out, you'll usually notice increased play or slop in the system. If it's in a boom pivot, for example, you might see excessive movement or feel a distinct 'clunk' when the boom is articulated, especially under load. This isn't just annoying; that extra movement can put undue stress on other components, like pins, bolts, and even the structural welds of the boom itself, potentially leading to bigger failures down the line. You might also observe a slight misalignment or a general feeling of looseness in the operation.

Replacing one of these isn't usually a huge job, but it's critical to inspect the mating surfaces thoroughly. Always check the pin or shaft that runs through it, and the bore it sits in. If those are scored or out of spec, a new SLEEVE won't last long. Make sure you clean everything up properly before installation, and if it's a press fit, ensure you're using the right tools to avoid damaging the new SLEEVE or the housing. And don't forget to grease it if it's a moving part; that's a common oversight that shortens its life significantly.