WATER METER

882 108 69 MEDIDOR is what keeps tabs on your water flow, usually for dust suppression or sometimes for flushing the hole. It's not just a fancy gauge; the rig's control system actually uses its signal to regulate the water pump or valve. If this thing isn't reading right, you're either drowning the hole or kicking up a dust storm, which messes with bit life and visibility, not to mention the environmental impact.

When this WATER METER starts acting up, you'll usually notice inconsistent dust suppression. One minute it's fine, the next you've got dust everywhere, or worse, you're making mud because the system thinks it's not getting enough water and overcompensates. Sometimes it just flat-out stops reading, and then your auto-drilling sequence might even fault out because it can't verify water flow. It's a real pain when you're trying to keep the site clean and safe.

Before you just swap it out, always check the screen or filter upstream of the meter. These things are pretty sensitive to debris, and a clogged filter can starve it of flow, making it read low or nothing at all. Also, make sure there's no air trapped in the line when you're commissioning it; air bubbles can really throw off the readings. A quick visual for leaks around the connections is always a good idea too.