TAPE

BG 008 032 08A TAPE that's typically a wear strip, isn't it? You'll usually find these tucked into the grooves on a hydraulic cylinder piston or sometimes on the rod gland. What it does is keep the metal parts from grinding against each other. It acts like a sacrificial buffer, maintaining a precise clearance between the piston and the cylinder bore, or the rod and its housing. This little strip is crucial for keeping everything aligned, preventing scoring on those expensive cylinder walls, and making sure your main seals aren't carrying all the side load. It basically guides the piston or rod true, keeping friction low and extending the life of the whole assembly.

When this wear TAPE starts giving up the ghost, you'll definitely notice a change. Usually what happens is the clearances open up too much, or the TAPE breaks down and bits of it get into the system. You might start seeing some cylinder drift, or the movement just feels a bit sluggish and jerky. Sometimes, you'll even hear a subtle grinding or squeaking if the metal-on-metal contact has started. The main seals, which are now taking all the side load, will fail pretty quick after that, leading to external leaks. And if it's really bad, you'll get scoring on the cylinder bore or rod itself, which is a much bigger, more expensive repair down the line.

Look, whenever you're tearing down a cylinder for a reseal, this wear TAPE is one of those 'always replace' items. It's cheap, and it saves you a ton of headaches later. Don't cheap out and reuse the old one, even if it 'looks okay'. Before you put the new one in, give that groove a good clean-out and make sure there's no burrs or old material stuck in there. And here’s a common one: always double-check the ends of the TAPE to ensure they're properly butted or chamfered according to the cylinder design, so you don't create a stress point or a path for debris.