TRACK ASSEMBLY PAIR

551 788 20 TRACK ASSEMBLY PAIR is the whole enchilada when it comes to moving your rig around the site. This assembly is the complete undercarriage unit – we're talking the track chain, the rollers, the idler, and the sprocket all working together. It's what actually puts the power from your final drives to the ground, allowing the machine to traverse rough terrain, climb grades, and position itself for drilling. Essentially, without this doing its job, your rig isn't going anywhere.

When this track assembly starts going south, you’ll definitely notice it. Usually what happens is the rig will feel sluggish, struggling to climb grades it used to handle easily, or you'll pick up some new, grinding noises from the undercarriage. You might also see the track chain getting really loose, even after you've tried adjusting it, which often points to worn pins and bushings or flat-spotted rollers. Excessive vibration when tracking is another dead giveaway, and if it gets bad enough, it can put a lot of extra stress on your final drives and even lead to premature wear on other components.

Replacing a track assembly is a big job, no two ways about it, but it's crucial for keeping your rig productive. When you're swapping one out, don't just slap the new track on without a good look at the drive sprocket. If those teeth are hooked or worn thin, you'll just chew up your new track prematurely. Also, always double-check the final drive mounting bolts and make sure they're torqued correctly. And don't forget to re-tension the track after a few hours of operation; they tend to settle a bit after initial installation.