STRIP

085 704 78 STRIP is essentially one of those critical wear surfaces that keeps your feed beam running true. Think of it as the low-friction liner that guides the drill string carriage up and down the mast. Without it, you'd have metal-on-metal grinding, which is a recipe for serious damage to the main beam structure and the carriage itself. It takes the brunt of the friction and keeps everything tracking straight, reducing side loads on the cylinders and ensuring smooth, consistent feed.

When these strips start to wear down, you'll definitely notice it. The most common thing is a bit of slop or play in the feed carriage. You might hear a new kind of clunking or rattling, especially when the rig's working hard or changing direction. Sometimes, you'll even see scoring marks appearing on the feed beam itself, which means the metal is starting to make contact. That's a clear sign you've waited too long, and you're now wearing out expensive structural components instead of just the sacrificial STRIP. It also messes with your drilling accuracy, causing the bit to wander a bit more than it should.

Replacing these isn't usually a huge job, but you gotta do it right. Always make sure the channel where the STRIP sits is clean as a whistle before you put the new one in; any grit or old debris will just chew up the new STRIP or prevent it from seating properly. Also, give a good look at the mating surfaces on the carriage for any damage or burrs that could accelerate wear on the fresh STRIP. Don't forget to check all the mounting hardware too; loose bolts can cause premature failure and more headaches down the line.