ADHESIVE LABEL

094 234 88 ADHESIVE LABEL While it may seem like a basic component, this ADHESIVE LABEL plays a key role in the overall reliability of your equipment. It is used to wrap and secure electrical wiring harnesses within control cabinets and along the boom and feed assembly. This bundling prevents individual wires from chafing against structural components or vibrating loose, which can lead to intermittent faults or complete electrical failure.

The integrity of the machine's control system depends on protecting its wiring. If this tape wears through, a wire can rub against a steel bracket and cause a short circuit, potentially shutting down the entire rig without warning. It also provides an extra layer of abrasion protection for hydraulic hoses, helping to prevent small leaks that can grow into significant and hazardous high-pressure oil sprays.

During routine inspections, look for any tape that appears brittle, is peeling away, or has been worn through. Pay close attention to areas where harnesses or hoses pass through bulkheads or bend around sharp corners. Replacing damaged tape is a simple, low-cost preventative measure that can save you from hours of troubleshooting and expensive component failures down the line.